How To Set Cruise Control On 2018 Subaru Outback

Cruise Command is a cool way to put your Subaru Outback on autopilot so to speak. In this setting, the vehicle can maintain speeds of 25mph or more without having to printing the accelerator. However, information technology will not gear up at below 25mph. In addition, the feature disconnects when the brake is applied. Albeit this is a wonderful feature, exist aware that prowl control can be unsafe on winding roads, in traffic, and on wet slippery or icy roads. With that being said, here are the uncomplicated steps to on how to set up your Cruise Control.

**Note: If you lot are unable to activate this characteristic on the first try, REPEAT the steps. If yous are still unsuccessful, contact the dealership for assistance or consult your vehicle user's manual.

Enable Prowl Command

Press the Cruise Control icon located on the RIGHT side of the steering wheel notated by the top arrow in the paradigm (CC Icon).
Once you reach your cruising speed, press the S ET/ − button (Middle Lesser).

*Cruise control is now SET and you will run across the following icon within the dashboard to inform you that information technology is now Active.

*You lot can now have your foot off of the accelerator and ride.

Additionally. you can press the RES/ + button to INCREASE your speed (Center Top).
Or printing the Due south ET/ − button to Decrease your speed. Both by 5miles only at a time.

Outback's Are Equipped With Cruise Control Eyesight

With Eyesight, if you gear up your Cruise Control speed to 50mph, still you notice information technology is only going 40mph, this is due to a vehicle in forepart of you. So if the vehicle ahead speeds upwardly, your vehicle volition increase the speed automatically to reach your Prepare cruising speed.

Another Eyesight Feature

*Nevertheless using the buttons on the Correct side of the steering wheel.

With your speed nonetheless Gear up, press the Acme LEFT button to move CLOSER to the vehicle ahead.
Press the Bottom LEFT button to movement FARTHER AWAY from the vehicle ahead.
If the vehicle ahead slows down, your Outback will besides, WITHOUT you pressing the brake. Crawly HUH!!
If you press the brake past mistake, simply press RES/ + to resume the previous speed .

Cancel Cruise Command

Stepping on the restriction lightly volition disengage the speed and volition relieve the previous set speed.
Pressing the Prowl CONTROL push will turn the system OFF .

Icons

A Car in a higher place a meter (On/Off) – Press to turn the organisation ON/OFF; Be sure the system is OFF when not using it as if RES/ + or Fix/ − is agile, you lot could accidentally hit either, which will cause your vehicle to enter cruise command mode automatically.
SET/ − (Ready/Coast) -Used to prepare or subtract your desired speed.
RES/ + – To maintain the desired speed or to accelerate the gear up speed. To increase the speed press this push.

Y'all are now ALL Gear up!